87-91 Ford F150/Bronco Rock Crawler Bumper
This is our 87-91 Ford F150/Bronco “Rock Crawler” front bumper. Designed to be the same width as the frame rails and pushed as close to the body as possible to allow a better approach angle. This kit is built from 1/4” steel plate as a “weld it yourself” kit or ready to paint (ready to paint available by email or call). Optional tow points are available as well, call or email for any add on choices you would like. We used a Badlands ZXR winch with a standard 4.5”×10” bolt pattern for our measurements. Other winches may require some modifications in order to properly fit. All mounting hardware is included for the bumper to the frame connection. Winch, winch hardware, fairlead, and fairlead hardware is not included. Actual product may vary slightly since all of our bumpers are assembled by hand in the great state of Montana. If you choose the “Weld It Yourself” option all welding should be done by a competent welder, Walter Metal Works is not responsible for bumper failure on “Weld It Yourself” kits. This bumper is for off-road use only and provides little to no real protection to your truck.
This is our 87-91 Ford F150/Bronco “Rock Crawler” front bumper. Designed to be the same width as the frame rails and pushed as close to the body as possible to allow a better approach angle. This kit is built from 1/4” steel plate as a “weld it yourself” kit or ready to paint (ready to paint available by email or call). Optional tow points are available as well, call or email for any add on choices you would like. We used a Badlands ZXR winch with a standard 4.5”×10” bolt pattern for our measurements. Other winches may require some modifications in order to properly fit. All mounting hardware is included for the bumper to the frame connection. Winch, winch hardware, fairlead, and fairlead hardware is not included. Actual product may vary slightly since all of our bumpers are assembled by hand in the great state of Montana. If you choose the “Weld It Yourself” option all welding should be done by a competent welder, Walter Metal Works is not responsible for bumper failure on “Weld It Yourself” kits. This bumper is for off-road use only and provides little to no real protection to your truck.
This is our 87-91 Ford F150/Bronco “Rock Crawler” front bumper. Designed to be the same width as the frame rails and pushed as close to the body as possible to allow a better approach angle. This kit is built from 1/4” steel plate as a “weld it yourself” kit or ready to paint (ready to paint available by email or call). Optional tow points are available as well, call or email for any add on choices you would like. We used a Badlands ZXR winch with a standard 4.5”×10” bolt pattern for our measurements. Other winches may require some modifications in order to properly fit. All mounting hardware is included for the bumper to the frame connection. Winch, winch hardware, fairlead, and fairlead hardware is not included. Actual product may vary slightly since all of our bumpers are assembled by hand in the great state of Montana. If you choose the “Weld It Yourself” option all welding should be done by a competent welder, Walter Metal Works is not responsible for bumper failure on “Weld It Yourself” kits. This bumper is for off-road use only and provides little to no real protection to your truck.